延安附近想过夜电话联系

Over 20 years of research and development, the company has produced more than 30 million high-quality customers
Focus on improving pass through rate for SMT Enterprises
lower production cost
0755-29749682
eighteen billion nine hundred and twenty-eight million four hundred and three thousand four hundred and thirty-five
Focus on improving pass through rate for SMT Enterprises
lower production cost
common problem
Your current position: home page / Lin Chuan information / common problem

Can you make steel mesh with PCB?

Source: Lin Chuan precision article author: Lin Chuan precision time: November 2, 2019 15:27 reading: 2444

Some netizens often ask me whether only PCB board (circuit board) can open a steel net. Here Linchuan precision answers "yes"

Why do some manufacturers say they can't open it?

Because the process of opening steel mesh with PCB board is a little complicated, and it needs to be copied. Some manufacturers have not advanced equipment or engineering technology problems, and often produce SMT steel mesh offset. For some reasons, this process is not carried out at all.

The following is an introduction to the steel mesh information, which can be handed over to SMT steel mesh factory to make steel mesh:

1) the first choice of steel mesh file is paste layer. Except for some special pads, the pads with holes on the steel mesh are basically on this layer, which is also a document acceptable to every steel mesh factory.

2) PCB format file. Since both PCB board making and steel mesh making will first convert PCB file into Gerber file, in theory, PCB file contains all the layers that should be available, and the steel mesh factory can pick out the layers needed for making steel mesh.

3) Gerber file, refers to the plate making engineering document exported by the plate making plant. This document does not contain the steel mesh layer, and many steel mesh factories do not accept such documents, because it is relatively cumbersome to select the steel mesh opening pad in combination with the whole set of engineering documents.

4) CAD file, which can be used by individual steel mesh factory, and Gerber file exported from CAD can be used.

More than one of the qualified information can be found in the steel network

Last article: How to use SMT steel mesh correctly
Next: How to choose high quality SMT steel mesh
Related information
Hot products
Linchuan precision company SMT steel mesh Manufacturer
Main business: Laser steel mesh Nano steel mesh
Stepped steel mesh FG steel mesh
Service hotline: 0755-29749682/18928403435
Shenzhen Linchuan Precision Technology Co., Ltd
Hotline: 0755-29749682 18928403435
Email: xjx.smt@163.com
Customer service QQ 2549201 25487
Address: 2 / F, block C, Fengrun building, gushiu Huafeng Second Industrial Park, Xixiang, Bao'an District, Shenzhen

Guangming branch: No.16, shangshijia Road, tangxiawei third industrial zone, Guangming District, Shenzhen Yue ICP Bei No. 17051183


Scan more
menu
Telephone About us share
shrink

Online Service

  • customer service  Click here to send me a message
  • customer service  Click here to send me a message
  • Miss Zeng
    eighteen billion nine hundred and twenty-eight million four hundred and three thousand four hundred and thirty-five
  • Mr. Luo
    eighteen billion nine hundred and twenty-three million seven hundred and sixty-eight thousand six hundred and fifty-seven
  • Scan more